Generator installation in Hazard, Perry County — quick facts
- Typical cost
- Whole-house standby generators $8,000–$16,000 installed, depending on size.
- How long it takes
- Most installations take 1–2 days once permits and the pad are ready.
- When you need it
- Before storm and ice season — installer lead times grow after every major outage.
- If you wait
- The next outage comes with no warning, and portable units can't safely run a whole house.
- Why it matters here
- Perry County's hollers lose power in every ice storm and flood — and mountain roads mean crews restore remote homes last.
Emergency generator repair
Power's out, the generator should be running, and it isn't. That's an emergency — especially in a January ice storm on a Perry County ridge. We diagnose and repair all major standby generator brands: no-start conditions, fault codes, transfer switch failures, and storm damage.
The single most common failure we see is a dead battery. Standby batteries last 2–3 years, and most homeowners never think about them until the outage arrives. If your unit is more than two years old and hasn't had a battery test, call before storm season — not during it.
Annual maintenance plans
A yearly service visit keeps your generator ready and protects the manufacturer's warranty:
- Oil and oil filter change
- Air filter and spark plug replacement
- Battery load test and terminal cleaning
- Coolant and fuel system inspection
- Full automatic transfer test under load
- Controller firmware and exercise-cycle check
Annual plans typically run $150–$300 per year — a fraction of one spoiled freezer or one burst pipe.
Signs your generator needs service now
- It hasn't run its weekly exercise cycle (check the controller display)
- Warning lights or fault codes on the control panel
- It's been more than a year since the last oil service
- The battery is older than 3 years
- It struggled or ran rough during the last outage
Repair & maintenance FAQs
Why won't my generator start in Hazard, KY?
The most common cause is a dead or weak battery — the #1 reason standby generators fail to start. Other causes include stale fuel, a failed starter, or a fault code locking out the controller. A diagnostic visit identifies the exact issue.
How often should a standby generator be serviced in Hazard, KY?
At least once a year: oil and filter change, air filter, spark plugs, battery test, and a full load-bank or transfer test. Units in dusty or high-run-time environments benefit from twice-yearly checks.
Do you repair generators you didn't install in Hazard, KY?
Yes. We service and repair standby generators from all major manufacturers regardless of who installed them, including units bought through big-box stores or other contractors.